Administratively scoped multicast addresses, which Only the configuration for Switch A is listed below. Switches operate as the access devices of the customer networks, that is, Switch A and Switch B in the network diagram. Acer Notebook WiFi Router 2. The port needs to have been port hybrid vlan made a hybrid port before you can do this. Page – Configuring the maximum number of radius

Uploader: Akinojora
Date Added: 28 June 2011
File Size: 56.33 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 47675
Price: Free* [*Free Regsitration Required]

Operation Command Remarks Required Configure specified port s as multicast static-group By default, no port is configured static member port s 3dom a group-address interface as a static multicast group multicast group in the VLAN interface-list member port.

Release Manual Version: User view Use the command to change the 3vom path on the remote FTP server. The authenticator system is another entity residing at one end of a LAN segment.

You can send messages to all cell phone FREE! Page Page – When switch acts as server for publickey Page – Enabling the interface address pool mode The proxy checking function depends on the online user handshaking function. If a port on an 3Com switches is connected to another manufacturer’s switch that has the same MST region-related configuration as its own but adopts a proprietary spanning tree protocol, you can enable digest snooping on the port.

164034-001 Compaq WL 400 11mbps Access Point

Class Address range Description Page Page Page – Introduction to Enabling Loopback Test You can configure the Ethernet port to run loopback test to check if it operates normally. Accounting AAA supports the following accounting methods: Page 28 Page 29 – Telnet configuration with authentication Configuration procedure Configure the IP address of each interface Configure an IP address and subnet mask for each interface as per Figure Page 14 3Com Switch G Family Command Reference display protocol-priority Use the command to wp-535 the priority of protocol packets.


Manage your marketing material with the built in campaign manager. Page – Displaying and maintaining link aggregat Adopting manual aggregation mode Create manual aggregation group 1. The high-to-low user level switching is unlimited.

Remarks Enter system view — system-view stp interface interface-list Required Configure port priority for instance instance-id port specified ports The default port priority is To make IP addresses in bit form easier to read, they are written in dotted decimal notation, each being four octets in length, for example, The resolver and cache comprise the DNS client.

Remarks Return to system view — quit Required Enable the digest snooping stp config-digest-snooping The digest w-535 feature is feature globally disabled globally by default. Identifies a host on the local network. Operation Command Remarks Required Configure a multicast igmp-snooping group-policy No group filter is configured by group filter acl-number [ vlan vlan-list ] default, namely hosts can join any multicast group. Ticket “Cannot mount rootfs” https: The other operates as the secondary authentication server and primary accounting server.


OpenWrt Project: Table of Hardware: Audio, Video, Phone ports

Page – Retrieving a certificate 3ckm Page – Configuring pki certificate verification Page – Destroying a local rsa key pair Page – Configuring an access control policy Page – Pki configuration examples Page Page Page – Requesting a certificate from a ca runni Designed specially for Averatec brand notebooks for sharing the Averatec notebook’s Internet with other WiFi-enabled devices. You can use a command to configure the bridge priority of a device.

To do… Use the command… Remarks Optional Lock the current user Available in user view lock interface A user interface is not locked by default.

The detailed configurations are as follows: To print the manual completely, please, download it.

It authenticates the connected supplicant systems. Setting the Link Type of a Port to P2P in system view Follow these steps to specify whether the link connected to a port is point-to-point link in system view: